Final version 0
This commit is contained in:
1 parent
9bdc2ee860
commit
e7388f2314
8 files changed
+88
-98
No files matched your search
@@ -11,6 +11,7 @@
|
||||
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
|
||||
%% SECTION %%
|
||||
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
|
||||
\vspace{-1cm}
|
||||
\section{Introduction}
|
||||
|
||||
\glsreset{rd}
|
||||
@@ -365,10 +366,12 @@ In comparison to the reference \ac{hevc}, quality improvements up to $1.42$~dB
|
||||
When comparing results for both test cases, it is noticeable that the proposed method is able to outperform the reference methods for both cases, regardless whether \ac{idr} frame loss is allowed or not (\LOSTALL and \KEEPINTRA, respectively).
|
||||
As the \ac{plr} increases, the gains of the proposed method decrease in comparison with the case where the \ac{idr} frames are delivered error-free (i.e., case \KEEPINTRA), due to the higher error propagation of the missing \ac{idr} frame. Moreover, the quality gains are lower in the \LOSTALL case when comparing with \KEEPINTRA for the same \ac{plr}, for both the \ac{ld} and \ac{ra}.
|
||||
Taking into account the above results and the spatio-temporal information shown in Table~\ref{TableTestSequences}, one can observe that the performance of the proposed method is lower for sequences with high spatial details and low temporal activity (e.g., BQSquare and Park Scene), which indicates higher effectiveness for video content with higher motion activity.
|
||||
%\HIGHLIGHT{complete with analysis of both cases}
|
||||
|
||||
|
||||
\begin{figure}[!b]
|
||||
\subsubsection{Influence of parameter $\gamma$}
|
||||
|
||||
|
||||
\begin{figure}[tb]
|
||||
\renewcommand{\FIGSIZE}{0.8\columnwidth}
|
||||
\centering
|
||||
%\includegraphics[width=\FIGSIZE,page=1]{\ImprovedErrorResilience/Results/PSNRversusGama}
|
||||
@@ -378,10 +381,6 @@ Taking into account the above results and the spatio-temporal information shown
|
||||
\label{fig:QualityVsGamma}
|
||||
\end{figure}
|
||||
|
||||
\subsubsection{Influence of parameter $\gamma$}
|
||||
|
||||
|
||||
|
||||
The influence of the $\gamma$ parameter used in Equation (\ref{eq:KFactor}) on the video quality was also evaluated, in order to check how the cost constrains affect the performance of the proposed method.
|
||||
Figure~\ref{fig:QualityVsGamma} shows the average quality gains of the proposed method in comparison to the reference \ac{hevc} (\REF) across all test sequences, for different values of $\gamma$.
|
||||
For the error-free case (PLR=0\%), the results in this figure show that increasing $\gamma$ leads to a decrease in the coding efficiency, especially in the \ac{ld} configuration.
|
||||
@@ -498,6 +497,15 @@ For lower \acs{plr}, since fewer frames are affected by data losses, the use of
|
||||
|
||||
\subsubsection{Quality evaluation}
|
||||
|
||||
\begin{table}[!t]
|
||||
\centering
|
||||
\caption{Average quality using redundant \ac{mv} selected by the proposed approach.}
|
||||
\TABLESVSPACE
|
||||
\label{tab:AverageQualityRedundancies}
|
||||
\TABLESVSPACE
|
||||
\input{\ImprovedErrorResilience/Results/TableResultsRandomLossMvRedundancies.tex}
|
||||
\end{table}
|
||||
|
||||
Table~\ref{tab:AverageQualityRedundancies} presents the average \ac{psnr} of decoded video for different \ac{plr} (columns~4~to~8) and for various percentages of \ac{mv} redundancy (third column). The absolute quality values are shown for the reference case (\NOREDUND) and \ac{psnr} gains are shown for three different levels of redundancy introduced by the proposed method (\DYN).
|
||||
This study was also conducted for the two different cases, with and without \ac{idr} loss.
|
||||
|
||||
@@ -510,14 +518,7 @@ In summary, the proposed method is able to select the most relevant motion \ac{m
|
||||
Moreover, the dynamic approach devised to select the best \acs{mv} also contributes to increase the overall performance.
|
||||
Thus, using the proposed two-stage approach to recover temporal predictions consistently improves the error robustness of \ac{hevc}.
|
||||
|
||||
\begin{table}[!t]
|
||||
\centering
|
||||
\caption{Average quality using redundant \ac{mv} selected by the proposed approach.}
|
||||
\TABLESVSPACE
|
||||
\label{tab:AverageQualityRedundancies}
|
||||
\TABLESVSPACE
|
||||
\input{\ImprovedErrorResilience/Results/TableResultsRandomLossMvRedundancies.tex}
|
||||
\end{table}
|
||||
|
||||
|
||||
\section{Summary}
|
||||
\label{Section4:Summary}
|
||||
|
||||
Reference in new issue
Block a user