persistent_notification: create: description: Show a notification in the frontend fields: message: description: Message body of the notification. [Templates accepted] example: Please check your configuration.yaml. title: description: Optional title for your notification. [Optional, Templates accepted] example: Test notification notification_id: description: Target ID of the notification, will replace a notification with the same Id. [Optional] example: 1234 homematic: virtualkey: description: Press a virtual key from CCU/Homegear or simulate keypress fields: address: description: Address of homematic device or BidCoS-RF for virtual remote example: BidCoS-RF channel: description: Channel for calling a keypress example: 1 param: description: Event to send i.e. PRESS_LONG, PRESS_SHORT example: PRESS_LONG zwave: start_network: description: Start the zwave network. This might take a while, depending on how big your zwave network is. stop_network: description: Stop the zwave network, all updates into HASS will stop. heal_network: description: Start a zwave network heal. This might take a while and will slow down the zwave network greatly while it is being processed. Refer to OZW.log for details. add_node: description: Add a new node to the zwave network. Refer to OZW.log for details. add_node_secure: description: Add a new node to the zwave network with secure communications. Node must support this, and network key must be set. Refer to OZW.log for details. remove_node: description: Remove a node from the zwave network. Refer to OZW.log for details. test_network: description: This will send test to nodes in the zwave network. This will greatly slow down the zwave network while it is being processed. Refer to OZW.log for details. soft_reset: description: This will reset the controller without removing its data. Use carefully because not all controllers support this. Refer to controllers manual.